Outputting GPS data from your B100 to external devices

If you would like to output GPS data from the B100 to external devices, please follow the steps below. 

Step 1 :Download and save the  "aisb.cfg" file on this page to a blank SD card (if you were sent a card to configure your B100, you can use this but any make of SD card up to 32GB in size will do)

Step 2: Turn the B100 off, insert the SD card containing the aisb.cfg file and then power on the unit again.  

Step 3: The LEDs will flicker for a short while and once they stop flashing, the new configuration is completed. (We suggest you turn the unit off and on again at this point)

Step 4: Connect the B100 to the ProAIS2 software included on the product CD and select which GPS sentences you want to output on the configuration page and then select "write configuration"

Your B100 should now be outputting the requested sentences from both High and Low speed NMEA ports!  Please be assured that by applying this config file, your vessel identification data (such as MMSI, Name, dimensions etc.) will not be altered.